Zircon Stud Finders / Stud Sensors
& Electronic Metal Finders
(aka StudFinders / StudSensors)

Normal mode detects wood or metal through up to ¾ inch of drywall.

Selectable DeepScan®

Stud Finder / Stud Sensor Models with DeepScan® can detect wood or metal studs and joists up to 1-½ inches deep. An indicator light tells you when DeepScan is active.

>> Back to Model Comparison Chart

TruCal® technology provides instant and accurate one-touch calibration each time the tool is used, ensuring accuracy for each and every job.

TruCal calibrates your ZIrcon electronic tool to the particular surface you want to scan.

When you place the Stud Finder / Stud Sensor against the wall and turn it on, it emits an electric field. The internal circuitry detects how much time it takes for the wall material under the StudSensor to reach a certain voltage. The circuitry then sets this as the zero level of capacitance, and the StudSensor is now calibrated.

>> Back to Model Comparison Chart

If a Stud Finder / Stud Sensor is inadvertently calibrated over a stud, it will intermittently beep and blink. Simply move the StudSensor several inches to the left or right and try again.

>> Back to Model Comparison Chart

When your Stud Finder / Stud Sensor detects a stud edge (or other targeted material), it emits a continuous audio tone. An intermittent beeping tells you that you've accidentally calibrated directly over a stud.

>> Back to Model Comparison Chart

SpotLite™ Pointing System

This revolutionary feature projects a beam of light over a target when it is found, adding another measure of confidence to any scanning task.

All SpotLite products feature a single button that turns the units on and triggers the TruCal instant calibration before each use. A separate LED illuminates when calibration is completed, a process that takes only a fraction of a second.

>> Back to Model Comparison Chart

AC WireWarning™

Tools with the WireWarning feature continuously detect hot electrical wires while scanning for studs, an important safety concern on any job.

WireWarning is always on, in all modes, to alert you to the presence of hot, unshielded AC wires behind the wall.

>> Back to Model Comparison Chart

Metal Scan

The metal scanning mode finds copper and steel up to 1-1/2 inches deep behind walls, floors, and ceilings, and rebar in concrete up to 3 inches deep.

Deep Metal Scan

The dedicated-to-metal MT6 finds rebar in concrete up to 6 inches deep, and differentiates between magnetic metals such as steel and non-magnetic metals such as copper. It also indicates the depth of the located materials.

* All Zircon Stud Finders / Stud Sensors find both wood and metal studs. Metal Scan allows the user to look only for metal.

>> Back to Model Comparison Chart

AC Scan allows you to turn off wood and metal scan to look only for hot AC voltage to find and trace wires, even in plastic conduit.

>> Back to Model Comparison Chart

Stud Finders / Stud Sensors find stud edges. To ensure you find the center of a stud, scan across the wall in both directions and mark each edge. The center of the stud will be halfway between your two marks.

>> Back to Model Comparison Chart